Description

When you’re running three-point implements behind your Massey Ferguson 135 or 240, that leveling box is what keeps everything working square and true. This solid left-hand Y-fork is the critical link between your tractor’s hydraulic system and your implements – whether you’re pulling a two-bottom plow through heavy clay or running a rotary cutter through overgrown pasture. When this fork starts to wear out, you’ll notice your implements won’t stay level, and that means uneven work and premature wear on your equipment.

What You’re Getting

Solid steel construction that eliminates the weak points you get with adjustable forks
Fixed 19-inch length gives you consistent positioning without worrying about threads wearing out
Heavy-duty Y-design spreads the load properly to reduce wear on your leveling box
Left-hand configuration mounts on the operator’s left side when you’re sitting on the tractor
Direct replacement that uses your original pins and hardware

Built for Real Farm Work

Your MF 135, 148, or 240 is likely the backbone tractor on your operation – the one that handles everything from cultivating corn to cutting hay to running a post-hole digger. These popular Massey Ferguson models handle diverse tasks on farms everywhere – from the versatile 135 running a rotary cutter to the powerful 165 pulling cultivation equipment. The leveling box is what lets you fine-tune your implement’s working angle and maintain consistent depth. This Y-fork is what makes that leveling system work, keeping your implements running parallel to the ground so you get even results every pass.

Made to Last

Unlike adjustable forks that can fail at the threads or adjustment mechanism, this solid fork eliminates those potential problem spots. The one-piece forged steel construction handles the constant lifting loads, shock from hitting rocks, and the twisting forces that come with tight turns at field ends. The Y-design distributes stress across multiple contact points rather than concentrating it in one spot.

Good to Know

Installation is straightforward – remove the pin from your worn fork, slide this one in, and reinstall the pin. Since this is the non-adjustable type at 19 inches, make sure that matches your current setup before ordering. Always replace both Y-forks as a pair if one shows significant wear – mismatched forks will cause leveling problems and uneven implement performance. Keep the pin greased to prevent binding and make future removal easier.