Description

If you’ve had your hydraulic lift cover off for repairs or seal replacement, chances are you need one of these plugs to get everything sealed up properly. This 3/8″ BSP plug is required for the hydraulic lift cover assembly and is one of those small but essential parts that keeps your three-point hitch system working like it should. Without the proper plug, you’ll lose hydraulic pressure and end up with a mess on your hands.

What You’re Getting

Precision-threaded 3/8″ BSP plug that seals tight and stays put
Pack of two plugs – handy to have a spare when you’re deep in a repair
Built to handle hydraulic pressure without backing out or leaking
Direct replacement that threads in smoothly without cross-threading

Built for Real Farm Work

This plug fits a wide range of Massey Ferguson tractors from the 100, 200, 500, and 600 series, covering everything from compact utility tractors to serious field workhorses. Whether you’re running a bush hog, pulling a disk, or operating a loader, these tractors depend on clean hydraulic systems for reliable three-point operation. The hydraulic lift cover needs to stay sealed to maintain proper system pressure for smooth implement operation.

Made to Last

Farm hydraulics take a beating from pressure cycles, temperature swings, and the inevitable bumps that come with field work. This plug is built from materials that resist corrosion from hydraulic fluid while maintaining a proper seal. It’s designed to stay tight through thousands of cycles without loosening up or developing leaks.

Good to Know

Thread the plug in by hand first to avoid cross-threading, then snug it down with a wrench – don’t over-tighten or you might damage the aluminum housing. Make sure to relieve hydraulic pressure before you start this job and clean the mating surfaces really well while you’re in there. A drop of hydraulic fluid on the threads helps prevent galling during installation.