Left Hand Torsion Spring for John Deere 1560, 1590, 1690, 1860, 1890, and 1990 Series Grain Drill Ca

Description

If you’ve been fighting with a closing wheel that won’t stay put or doesn’t apply enough pressure to properly close the seed furrow, chances are the torsion spring is worn out or broken. This left-hand spring provides the tension that keeps your cast closing wheels doing their job—sealing that seed trench so your crop gets the best start possible.

What You’re Getting

• Precise left-hand torsion design that matches factory specifications
• Consistent spring tension to maintain proper closing wheel pressure
• AgSmart quality construction built to handle the stress of field work
• Direct replacement for worn or broken original springs

Built for Real Farm Work

This spring fits John Deere grain drills including the 1560, 1590, 1860, 1890, and 1990 series, plus the 1690 model. These are the workhorses you rely on for getting wheat, soybeans, and small grains in the ground efficiently, whether you’re no-tilling into stubble or working prepared ground.

Made to Last

Torsion springs take a beating from constant flexing, dirt, and moisture, but this replacement is built to handle the punishment. The spring steel holds its tension season after season, so you won’t be replacing it again anytime soon. It’s designed to work with cast closing wheels that need reliable pressure to firm the soil over your seed.

Good to Know

This is specifically the left-hand spring, so make sure you’ve got the right side before ordering. Installation is straightforward if you’ve worked on closing wheel assemblies before—just remember to relieve the spring tension carefully when removing the old one. A good time to replace these is during off-season maintenance when you’re already checking your closing wheel setup.