Description

When your hydraulic cylinder starts getting loose or sloppy in its mounting points, it’s usually the clevis pin that’s worn out. This little guy takes a beating—constant pivoting under load, dirt, and the general abuse that comes with farm work. A worn clevis pin can cause cylinder drift, uneven operation, and eventually damage to the clevis ears themselves if you let it go too long.

What You’re Getting

Precision 1-1/4 inch diameter pin built to handle heavy hydraulic loads
Zinc plated finish that resists corrosion and extends service life
Clips included so you’ve got everything needed for a complete installation
Direct replacement for Cross DB cylinder series—no modifications required
Proper hardness and strength to maintain tight tolerances under pressure

Built for Real Farm Work

This pin is designed specifically for Cross DB series hydraulic cylinders with 3, 3-1/2, and 4 inch bore sizes. These are the workhorses you’ll find on loaders, backhoes, snowplows, and all kinds of implements where you need reliable hydraulic power. Whether you’re lifting hay bales, pushing dirt, or angling a blade, this pin keeps your cylinder properly positioned and operating smoothly.

Made to Last

The zinc plated finish helps this pin stand up to moisture and the elements, which matters when your equipment sits outside or works in muddy conditions. The steel construction is heat-treated to the right hardness—tough enough to handle the loads but not so hard it becomes brittle and breaks.

Good to Know

Before you pull the old pin, take a close look at the clevis ears for any wear or cracking. A little cleanup with a file or sandpaper can help the new pin fit properly. Keep the old clips as spares if they’re still in good shape—you never know when you’ll need them in a pinch.