15 Inch Hardsurfaced Hi-Wing Furrower for Moldboard Plows and Tillage Implements

Description

When you’re working tough ground or rocky fields, your plow points take a beating. This 15-inch hardsurfaced hi-wing furrower is built to handle whatever your soil throws at it. The hardsurfaced edge means it’ll stay sharp longer and cut through compacted soil, crop residue, and roots better than standard points that dull quickly.

What You’re Getting

• Hardsurfaced cutting edge that stays sharper longer in abrasive conditions
• 15-inch width provides excellent soil penetration and turning
• Hi-wing design for better soil flow and reduced draft requirements
• 1/4-inch thick construction handles rocks and tough conditions
• Standard 2-1/4 inch bolt spacing fits most moldboard plow setups

Built for Real Farm Work

This furrower is designed for moldboard plows and primary tillage work where you need consistent penetration and good soil turnover. Whether you’re breaking ground for corn, preparing seedbeds, or burying crop residue, the hi-wing design helps move soil efficiently while reducing the load on your tractor.

Made to Last

The hardsurfacing on the cutting edge is what makes this point special. It’s a harder material welded onto the steel that resists wear from rocks, sand, and abrasive soils. You’ll get more hours between replacements, and when it does wear, you can flip it over for extended life before needing the replacement tip.

Installation Notes

Mounts with either two 7/16-inch plow bolts or a single 5/8-inch carriage bolt, depending on your plow setup. When the hardsurfaced edge wears down, you can replace just the tip using part 2127-H1120UB instead of buying a whole new point. Check your bolt torque after a few hours of use to make sure everything stays tight.