Description
When you’re rebuilding that trusty Case 124 CID gas engine and need an overbore setup, this ring set gets you back to full compression and power. Whether your cylinder walls have seen too many hours or you’re just freshening up during a winter rebuild, proper ring sealing is what makes the difference between a strong-running engine and one that burns oil and lacks power.
What You’re Getting
- Complete set for 3-7/16 inch overbore pistons with proper ring gap spacing
- Three 3/32 inch compression rings plus one 3/16 inch oil control ring per cylinder
- TISCO quality construction built to handle farm work demands
- Direct replacement design that follows original Case specifications
Built for Real Farm Work
This ring set is designed specifically for the 124 cubic inch 4-cylinder gas engines that powered many Case tractors. These engines were workhorses that handled everything from field cultivation to belt work around the farm. When properly rebuilt with quality rings like these, they’ll give you years more reliable service pulling implements and running equipment.
Made to Last
TISCO builds these rings to handle the temperature swings and loads that farm engines see daily. The materials resist wear while maintaining proper tension against cylinder walls, and the ring design promotes good oil control without excessive friction. When installed with proper honing and clearances, these rings will seal tight and stay that way.
Good to Know
This is a complete set for one engine rebuild. Make sure your machinist checks ring end gaps and adjusts them for your specific overbore if needed. Clean ring grooves thoroughly during assembly and use a ring compressor for installation to avoid breaking rings. Check your cylinder taper and out-of-round measurements before ordering—some cylinders may need more than a 3-7/16 inch overbore.
Reviews
There are no reviews yet.