Spring Roll Pin for Agricultural Equipment – 5/16 x 1-3/4 Inch Hardened Steel

Description

You know how it goes—you’re in the middle of a job and hear that telltale ping of a roll pin letting go. Maybe it’s holding a lever in place, securing a clevis, or keeping a handle from spinning. Whatever the case, when these little guys fail, your whole operation comes to a stop. This 5/16 inch by 1-3/4 inch roll pin gets you back in business with a reliable, direct replacement.

What You’re Getting

• Spring steel construction that flexes to grip tight in the bore
• 5/16 inch diameter by 1-3/4 inch length fits a wide range of agricultural applications
• Split design compresses during installation then springs out to lock in place
• Hardened steel resists shearing and maintains its grip under load
• Works in everything from implement linkages to control levers

Built for Real Farm Work

Roll pins are the unsung heroes of farm equipment—they’re found in tractors, implements, and attachments wherever you need to secure parts that might see rotation or side loads. From PTO shafts to three-point hitch components, cultivator shanks to mower deck assemblies, these pins handle the job of keeping moving parts properly aligned while allowing for the controlled movement they’re designed for.

Made to Last

This isn’t some hardware store pin that’ll work its way loose after a season. The spring steel material is heat-treated to the right hardness—tough enough to resist breaking but with enough give to maintain tension in the bore. The split design means it compresses as you drive it in, then expands to grip the sides of the hole.

Good to Know

Roll pins install best when you use a proper roll pin punch—the hollow end prevents you from collapsing the split. If you don’t have one handy, a socket that’s slightly smaller than the pin diameter works in a pinch. Drive it in until it’s just below flush, and it’ll hold tight for years of service.